What Size Sand Filter Do I Need for My Above Ground Pool?

Operating the right size sand filter in your above ground pool will assist you to save money and energy. On the other hand, picking one of them is too small or too large can be problems with the whole system. Go through it to know how to calculate the right size sand filter for your above ground pool. So getting the right size sand filter for your above ground pool, you need to take into account some bullet points.

Measure the size of your Pool:

If your above ground pool is round, you have to measure the diameter along with center depth. Most of the above-ground pools don’t come with a “deep end” that is enough deeper than other segments of the pool. After that, you have to take into consideration of the calculation of the number of gallons of water in your above ground pool. Do so by enhancing the total volume of your pool times 7.48, and the amount of the water in a cubic foot of space. For a 24-feet diameter pool along with a center depth of 48-inch, the above-ground pool can hold all but 14,000 gallons.

Calculate the gallons to be filtered in eight hours:

A perplexing sand filter has the ability to clean all the water in the above-ground pool in eight hours. This is the minimum rate you desire to get the pump to be able to work at. When we divide 14,000 by 8, we will approximately get 1,750. After that, divide that answers by 60.

Determine the maximum flow rate:

Various types of pipe diameters can handle different types of flow rates. A 1-1/2-inch diameter pipe has the ability to carry approximately 45 gallons of water per minute. This is well above the minimum constraint for a 14,000-gallon pool. Pick a sand filter and pump along with 1.5-inch piping, which is rated for a GPM between 30 and 45. Try to keep the pipeline as straight as possible, along with a few turns and rises.

Filter systems:

You know that there are three major filter systems used for both in-ground and above ground pool: DE (stands for diatomaceous earth), sand, and paper cartridge. Among then sand filter system must help you clean your water of the above-ground pool. If you want to get a filter that comes with minimal maintenance with maximum performance, I will recommend you invest in a sand filter. This is guaranteed that you will never have to change, clean, or purchase cartridges. The only necessary maintenance is to backwash the sand filter, which you will have found in the filter manual.
Choose the largest-capacity sand filter you can purchase that has the capability of operating well along with the flow rate of your pool. This will make certain the best performance with the least amount of maintenance duration.

Install your sand filter:

Make sure that your sand filter is set on a solid concrete base to decrease vibration. House the electrical process of the pump under a watertight cover in order to prevent electrocution.
Other items to install with your sand filter:
For non-cartridge filters, you have to install a backwash hose, and air relief valve, and a sight glass pipe. Assemble a pressure gauge to all pumps that can measure up to 60 psi.


Considering the above discussion, it can be said that your right size sand filter depends on your fixed spaces. Space is the main thing to set the sand filter, and then it works according to its requirements.

Previous post 5 Tips on Budgeting For Your New Business
Next post What’s the Best Way to Sell Your Old Car?

Leave a Reply

Your email address will not be published. Required fields are marked *